Sheet and billet, to spec
Metal is supplied to the tolerances component manufacturing actually needs.
WHY SANASA
Component lines can't run on inconsistent metal.
We buy back your scrap
Clean production offcuts come back to us, closing the loop instead of sitting as waste.
Consistency, order to order
The same grade and quality standard applies whether it's your first order or your fiftieth.
Built for recurring supply
We're set up for standing orders, not just one-off lots.
Ferrous and non-ferrous metal for component manufacturers, plus scrap recovery from production offcuts.
We also buy back clean production scrap, closing the loop on offcuts that would otherwise sit as waste.
- Sheet and billet-grade metal
- Production scrap buy-back
2DIRECTIONS — SUPPLY & SCRAP BUY-BACK
1STANDARD, EVERY ORDER
0IDLE PRODUCTION OFFCUTS
100%TOLERANCE-CHECKED METAL
“A component line doesn't have room for inconsistent stock. We hold the same grade and tolerance whether it's your first order or your fiftieth.”
THE DIFFERENCE
A typical metal supplier vs. working with us.
Typical setup
- Quality varies between orders and suppliers
- Production scrap sits as a waste line item
- One-off lots prioritised over standing orders
- Grade confirmed only if there's a defect
Working with SANASA
- Same tolerance and grade, order after order
- Production scrap bought back, not wasted
- Standing orders built into how we operate
- Grade checked before the metal ships
WHO THIS IS FOR
Component manufacturers
Automotive parts producers who need sheet and billet-grade metal, and a buyer for clean production scrap.
MORE FROM INDUSTRIES